Linear Gate Repair Nationwide | Gatewood Fence & Gate

Linear Gate Repair in Coppell: What to Know First

Linear gate repair in Coppell typically runs between $185 and $640 depending on what failed, and most jobs are finished the same day we show up. We’re an independent Linear service provider, which means we fix the operator, the hinge, the board, or the limit switch without trying to sell you a whole new system. Hal Gatewood has been working on Linear gates around Coppell since 2001, and the diagnostic is always free with the repair. If you’ve got a Linear gate acting up, call (903) 829-4499 and tell us what it’s doing wrong. We answer the phone.

Call (903) 829-4499

This page is for Coppell homeowners with a Linear opener that won’t open, a gate that sags, hinges that squeal, or a remote that quit working. We’ll walk you through what actually goes wrong with Linear equipment, what it costs to fix, and how we handle the job from start to finish.

How Linear Products Fail - and How We Fix Them

• Linear LDO series limit switch drift. The Linear LDO50 and LDO33 residential swing-gate operators use mechanical limit cams that wear down over years of Texas heat cycles. When the cams get sloppy, the gate slams at the end of travel or stops six inches short of the close position. The fix is resetting and often replacing the limit assembly, not the whole operator. We carry the parts in the truck, and we set the limits properly before we leave, because a gate that never fully closes is a gate that invites everything from stray dogs to solicitors.
• Control board capacitor failure in Linear DCM and LDO models. North Texas summer heat gets into the control board housing, and the electrolytic capacitors on older Linear boards dry out. The symptom is a gate that works fine in the morning and then flips into lockout mode at 3 p.m. when the housing hits 140 degrees on the inside. Other companies swap the entire board. We test the capacitors and replace the failed ones when that’s the honest fix, which keeps a $500 board out of the landfill and saves you about $300.
• Faulty photo-eye alignment on Linear APeX and LDO gates. When Coppell’s clay soil shifts with drought and rain, the gate posts move a fraction of an inch. That’s enough to knock the photo eyes out of line, and the safety circuit refuses to let the gate close. Most of the time it’s not a bad sensor at all, it’s a post that’s moved. We realign the eyes, tighten the post if it needs it, and the gate closes like it should. Some companies will sell you new photo eyes and send you the bill. We’d rather fix the actual problem.
• Actuator arm wear on Linear swing gates. The actuator arm on Linear LDO swing operators takes the full push and pull force every single cycle. Over five or six years, the internal gears wear enough that the gate starts moving in a jerky, stutter-step motion. Homeowners often think the motor is dying. It’s usually the actuator head, and that’s a $180 to $260 repair instead of a $1,200 operator replacement. This is the kind of thing you find when you actually take the cover off and look.
• Remote receiver board failure from power surges. Lightning strikes and grid flickers across Coppell are hard on Linear receiver boards. The gate still opens from the wired keypad but the remote stops responding entirely. Sometimes it’s the receiver module itself, sometimes it’s fried from the surge. We test it before we quote it. If we can replace just the receiver card, that’s what we do. The last thing we want is for you to buy a new remote that doesn’t work either because the receiver was the problem the whole time.

Our Linear Gate Repair Process

1. 1
   You call and a person answers. Not a voicemail, not a routing menu. You describe what the gate is doing or not doing. We’ll give you a straight answer about whether it sounds like a quick fix or a longer job, and we schedule a window we actually keep.
2. 2
   We diagnose the gate where it stands. Hal or one of his crew shows up, runs the gate through its cycle, and checks the operator, the hinges, the posts, and the wiring. We test before we quote. The price you get after diagnosis is the price you pay. There’s no surprise line item added at the door.
3. 3
   We make the repair-or-replace call honestly. If the part can be rebuilt, welded, or repaired with quality aftermarket components that meet original specs, that’s what we recommend. If the part is genuinely dead and OEM is the only thing that will hold up, we tell you that too. We don’t sell you parts you don’t need. Hal’s been known to talk people out of repairs they didn’t actually need.
4. 4
   We fix it on site, same visit in most cases. We carry the common Linear parts on the truck: limit switches, capacitors, receiver boards, actuator heads, hinge bearings. If the job needs a part we don’t have, we order it and come back at the time we promised. For welding work on gates and gate posts, we weld right there in your driveway so the gate never has to leave your property.
5. 5
   We test the gate through a full cycle, twice. Open, close, obstruction test, remote test, keypad test. Then we show you what we did and what to watch for. If something acts up within 90 days, you call and we come back. That’s the Done Right Promise, and it’s in writing on your invoice.

What Linear Gate Repair Costs in Coppell

Here’s where the money actually goes on a Linear gate repair, based on what we see in Coppell week over week:

What moves the price is whether the part can be rebuilt or needs to be replaced, and whether the post has shifted. We quote the repair before any work starts, so you know the number walking in. Estimates are free, and if you’ve got a written quote from someone else, we’ll give you a free second opinion on it. Call (903) 829-4499 for an exact price on your Linear gate.

Why Coppell Homeowners Call Gatewood Fence & Gate for Linear Work

Hal Gatewood grew up about a mile from Old Town Coppell and has been fixing gates in this town since 2001. The name on the shop is his name. The address is published. The license number is there for anyone who wants to look it up. That’s the kind of accountability you can’t get from a company that mails you a quote from an office in another state.

We service nine gate brands, so if you’ve got a Linear on the driveway and a LiftMaster on the back fence, one trip covers both. We also work on Mighty Mule, Ghost Controls, and DoorKing, which means we’re not trying to sell you on one brand over another. Every repair carries the 90-Day Done Right Promise in writing. If it’s not right, we come back and make it right. No runaround, no fine print. And we answer the phone around the clock, because a gate that won’t close at midnight doesn’t care about business hours. Neither should we.

FAQs