Ghost Controls Gate Motor & Opener Nationwide | Gatewood Fence & Gate

Ghost Controls Gate Motor & Opener in Coppell: What to Know First

We’re an independent Ghost Controls service provider in Coppell, and we repair, install, and tune Ghost Controls gate motors and openers every week. Most Coppell jobs are done in one visit, same day when the part is on the truck. You get a straight price before we turn a wrench, and every job carries our 90-Day Done Right Promise in writing. Call (903) 829-4499 and a live person answers, day or night.

Call (903) 829-4499

This page is for Coppell homeowners who own a Ghost Controls gate opener and want to know what’s wrong, what it costs, and who they can trust to fix it without getting sold parts they don’t need. If that sounds like your situation, you’re in the right place.

How Ghost Controls Products Fail - and How We Fix Them

Ghost Controls builds a solid residential opener. But every brand has its weak points, and after 29 years of gate work around Coppell, we know exactly where Ghost Controls units tend to give up first. Here’s what we see most often, and what we do about it.

• AXDP and AXD series arm actuator drift. The Ghost Controls AXDP and AXD linear arm models can lose their limit positions, especially after a power flicker or a hard stop when a kid hangs on the gate. The symptom is a gate that opens fine but closes two inches short, or slams at the end of travel. We re-set the limit switches properly and re-learn the travel, then test it through a full cycle. A lot of handymen just loosen the arm and eyeball it, and the gate never closes square again.
• Control board failure from Coppell lightning and power surges. This is a Texas reality, not a Ghost Controls design flaw. Coppell gets real lightning storms, and a surge that rides in through the power line can take out the control board before the breaker even thinks about tripping. The R-series and TSS1 boards are particularly sensitive to this. When we see a dead board, we check the surge protection on the circuit and recommend a whole-outlet surge suppressor if the home doesn’t have one. Then we replace the board with an OEM unit so the warranty stays intact.
• Battery backup that won’t hold a charge. Ghost Controls sells battery backup kits designed to pair with their openers, and we’ve found the factory batteries generally last three to four years in Coppell’s heat before they stop holding enough charge to cycle the gate more than once. The giveaway is a gate that works on AC power but drags or dies the moment the power goes out. We test the battery under load, not just with a voltmeter, and replace it with a properly rated equivalent when it’s done.
• Photocell and edge sensor false trips. Ghost Controls safety sensors are consistent, but the wiring connections at the gate post take a beating from sun and sprinkler overspray. When the gate reverses for no reason or won’t close at all, it’s usually a corroded sensor wire or a photocell that’s drifted out of alignment. We trace the wiring, clean the connections, realign the eyes, and seal the junction so it stays dry. Fix the sensor and you fix the gate closing on its own.
• Remote range that shrinks over time. Ghost Controls remotes run on standard frequencies, and Coppell homeowners often find their range drops from fifty feet to ten feet without warning. We see this most on the older TDS2 and TSS2 openers. The culprit is usually antenna damage or a receiver module that’s drifted off frequency over years of Texas heat cycling. We replace the receiver or re-route the antenna, then re-pair your existing remotes so you don’t have to buy new ones unless they’re genuinely dead.

Our Ghost Controls Gate Motor & Opener Process

Here’s how a Ghost Controls gate motor job goes at Gatewood Fence & Gate, from first call to final test. No surprises, no mystery charges.

1. 1
   You call (903) 829-4499. A live person answers, asks what the gate is doing wrong, and schedules a time that works for you. We don’t use a voicemail queue.
2. 2
   We show up and listen. Before we touch anything, we watch the gate run a full cycle and ask you what it was doing the day it stopped working right. Tell me what it’s doing wrong and I’ll tell you what it’s going to take - no runaround.
3. 3
   We diagnose and give you a written price. We check voltage to the board, test the capacitor, inspect the arm or actuator, and verify the limit settings. Then you get one number for the repair, parts and labor included, before any work starts.
4. 4
   Parts decision, OEM vs. aftermarket. For Ghost Controls boards and motors, we use OEM parts by default because it protects your warranty and the opener’s long-term performance. For brackets, hardware, and accessories, we’ll tell you honestly where a quality aftermarket part saves you money without costing you reliability.
5. 5
   Repair, test, and clean up. We make the fix, run the gate through a full open-close cycle under load, check the safety reverse, and leave the site the way we found it - only working.
6. 6
   90-Day Done Right Promise. Every Ghost Controls repair carries our written guarantee. If it’s not done right, we make it right. One call brings us back, no runaround.

Most Ghost Controls gate motor repairs in Coppell are completed in one to two hours on site. We carry the common Ghost Controls parts on the truck, so we’re not making you wait for a second visit.

What Ghost Controls Gate Motor & Opener Costs in Coppell

Honest numbers, because you deserve to know before the truck rolls. These are what we actually charge for Ghost Controls work in Coppell, not a national call center’s “starting at” price.

• Limit switch reset and arm adjustment: $85 to $150. This fixes the gate that closes short or slams, and it’s a same-day fix when the arm itself is still sound.
• Photocell or edge sensor repair: $120 to $220. Includes wiring trace, re-termination, and realignment.
• Control board replacement (OEM Ghost Controls): $280 to $420 installed. The board is most of that. We show you the failed board before we swap it.
• Battery backup replacement: $140 to $240 depending on the kit and battery size. We test the old one under load first so you know it’s actually dead.
• Full opener replacement (motor, arm, board, remotes): $900 to $1,600 installed. This is a measured job, not a same-day call. We order the right Ghost Controls unit for your gate weight and use cycle, then install it with the limits set correctly from day one.

What moves the price: gate weight and length, whether the operator is an arm-style or slide motor, and how much of the existing wiring is salvageable. Coppell’s clay soil shifts over time, and we sometimes find the gate post has moved enough that the operator is fighting the hinge line. If that’s the case, we tell you before quoting the motor work, because fixing the motor without addressing the post means you’ll be calling us again in six months.

Estimates are free. You agree to the price before we start, and the price does not change at the door. Call (903) 829-4499 for a straight answer on your Ghost Controls opener.

Why Coppell Homeowners Call Gatewood Fence & Gate for Ghost Controls Work

I’m Hal Gatewood, and I’ve been working gates in Coppell since 2001, when I decided I’d rather fix things with my hands than sit in an office. I grew up about a mile from Old Town Coppell, so this isn’t a territory to me - it’s home. The name is on the shop, and the shop is down the road. That’s the oldest accountability there is.

We’re an independent Ghost Controls service provider, not a factory arm, which means our loyalty is to you, not to a warranty-voiding parts policy. We service Ghost Controls alongside LiftMaster, Mighty Mule, and DoorKing, so if your Ghost Controls opener is truly beyond saving, we’ll tell you honestly and show you what a replacement costs across brands - not just the one we happen to stock. The person who shows up at your gate is background-checked and uniformed, and every job carries our 90-Day Done Right Promise in writing. We answer the phone 24/7. Not a voicemail, not a call center three states away. A person.

We also offer $40 off any repair over $200, no trip charge inside the county, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. No haggling required - those are standing offers, and they’re on the invoice.

FAQs